Access Door Entry Keypad

Access door entry keypad provides comprehensive access control for all outdoor and indoor locations. Door/system status is indicated by a high intensity LED light source and an audible sounder. Access door entry keypad is specified to survive in different service environments, ranging from exposed unsupervised public locations to general service indoor applications. Keypads in the access control system range are dimensionally and electrically interchangeable. This allows users, entering codes at both outdoor or indoor access points, to establish and maintain familiarity with the keypad features.

1. Parameter ofaccess door entry keypad

2. Dimension Drawing:

3. Electrical and data connections

Pin 1: GND-ground

Pin 2: V- --Power supply negative

Pin 3: V+ -- Power supply positive

Pin 4: Signal-Door/call bell-Open collector gate

Pin 5: Power- Power supply for door/call bell

Pin 6&7: Exit button- Remote/exit switch- to open door form secure area

Pin 8: Common- Door sensor common

Pin 9: NO sensor- Normally open door sensor

Pin 10: NC sensor- Normally closed door sensor

Note: When making connection to the door strike, select door sensor normally open or normally closed to suit the intended application and locking mechanism.

4. Installation instructions

Fixing instructions: please read carefully before commencing installation.

A. Using the case as a template, mark the position of the four hoes on the surface.

B. Drill and plug the fixing holes to suit fixing screws(supplied).

C. Run the cable through the sealing grommet.

D. Secure the case to the surface using the fixing screws.

E. Make the electrical connections as shown in the below wiring diagram to the connector block.

Connect the casing to the earth.

F. Fix the keypad to the rear case case using the security screws(Use the nnylon sealing washers under the screw heads)